How to Take Measurements From an Existing Kilt

[The Wizard of BC]

There are a couple of different ways to measure a kilt depending on how it is made.

An Iconic Style kilt is measured differently than most others.

The length of an Iconic Style kilt has two parts - The Drop and the Rise. When you add these together they are the total length of the kilt.

The reason for this is that an iconic style kilt is flared out, above the top straps, to go up, over the bottom of the ribs.



The smallest part of the kilt is at the level of the top straps.

So the length part called The Drop, is measured from the bottom selvedge edge, up to the center of the top strap. The part above the top strap is The Rise.



Again, depending on the style of kilt, the Rise may be 1" - 2" - 3" and in some very old military kilts 4-5 inches.

Here are three kilts. Each has the same Drop, and fit the same person, but kilt on the left has 1" Rise. The middle kilt has a 2" Rise and the RRS kilt on the right has a 3" Rise.




On many kilts made today there is no flare above the top strap. The smallest part of the kilt is above the top strap at the waistbanding.
This style of kilt will usually have the length listed, not as Drop + Rise, but as a single total length from the bottom of the selvedge to the top of the waistbanding.






You need to know this to accurately measure the waist circumference of the kilt.

At the smallest part of the kilt, stretch a tape measure from the right edge of the outer apron - across the apron and continue until you reach the right edge of the under apron.

(Do not include the width of the under apron.)




There is one other caution -
On kilts made In Accordance With (IAW)- "The Art of Kiltmaking" - There will be one inch more on the fringed edge of the outer apron than on the other edge. This is to allow the fringe to overlap the Reverse pleat a little.



If you have a kilt like this subtract 1" from the total waist above.

To measure the hip circumference you stretch a tape measure similarly to how you did the waist circumference but now down at the level of the bottom of the Fell Area.
You can find the bottom of the Fell Area by reaching into the pleats and find where the Fell Stitching ends. This should be the Hip line of the kilt.



Most kilts out there are measured using only three measurements -

1) The Waist circumference
2) The Hip circumference
3) The Length or (Drop + Rise)

There are other ways to measure for kilts such as those that belong to the Contemporary style but as you are asking about an existing kilt I doubt you will need -

4) The Fell Length
5) The Front Slope
6) The Rear Slope.

So I won't cover the additional measurement in this post.