X Marks the Scot - An on-line community of kilt wearers.
|
-
3rd September 06, 08:01 AM
#11
A slight delay, but I'm on the job now....
The design, the buckle made of plastic modelling sheet and the pewter cast of it.
I'll now further shape the pewter casting...when finished, this will be used to make the production mold.
The buckle will be 8.5cm x 7.2cm, 4mm thick, 140 to 150 grams, a 5.5cm (almost 2.25") wide belt will fit.
The buckle will cost $12.50 +p&p.
I'll post pictures of the final result...polished and weathered versions...next week.
I hope this is what you have in mind 
Last edited by Robin; 3rd September 06 at 08:08 AM.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks