Stillwater Kilt question...

**Snow Dog** · 9th June 04, 11:13 AM

Hullo gents,
I've just purchased a kilt from stillwater but I need to re-alighn the first pleat. any recomendations on how to do this easily and with minimal risk of ruining the kilt? I totally dig it otherwise but the first pleat stick out a we bit and looks kind of silly...

any advice is appreciated...

Thanks...

**bubba** · 9th June 04, 11:42 AM

Look here, it's from Stillwaters site and addresses than among other modifications. http://www.stillwaterkilts.com/downl...structions.pdf

**The Kilted Chef** · 10th June 04, 07:59 AM

I second that, Bubba. Just follow the instructions about re-positioning the pleats and iron. That's it!

Larry

**Blu (Ontario)** · 10th June 04, 03:23 PM

I posted on this problem a while back. It seems that the condition exists mostly with light to medium fabric kilts. I was able to minimize the effect by both leaving a little more slack in the lower right hand side strap, and re-positioning the offending pleat by marking the correct position while being worn and then re-ironing. You can also rotate the kilt on the hips slightly in that direction to lessen the pulling effect .