
Originally Posted by
Dollander
Perhaps you could use Barbara Tewksbury's flash-making technique. The post about it on this forum was most likely trashed by Photobucket, but the instructions are included at the end of the box-pleated supplement for TAoK:
http://scottishtartans.org/pdf/Box_p...es_ver_1.1.pdf If you're really that bad with a needle, you could even secure the folded-over edge with more iron-on hem tape, and glue the Velcro to the elastic (with actual Velcro glue; sticky-back will not hold as well), or just buy pre-made garters. And then you could fringe the edges rather than cutting them into a chevron (though make sure the fusible web stops short of the part you want to fringe) to achieve a similar look. I know it's not the same as actual self-tied garters, but considering that we wear tailored kilts now rather than hand-pleated phillabegs...

A very interesting read, skimmed the instruction and history of the Box Pleated Kilt. On a side note I see my Utility Kilt is Box Pleated in a way with wide pleats. The instructions on making the Flashes are quite easy to understand. Will have to try my hand at it, I bet one could make the double fabric (a shorter piece of fabric in front of a longer bit of fabric) two piece flash set, like the navy blue and black set of flashes I have now.. Thank you for sharing, gives me something new to work on.. I have noticed that Tartan Flashes don't seem to have this shorter bit of fabric in front of the longer piece of fabric... May have to experiment...
Bill...
“Canadian Grown and Raised from Scottish Roots!”.....
"Clan Farquharson, & Clan Fraser of Lovat"....
Bookmarks