Front apron left pleat not laying flat

[Barb T]

The other culprit can be not making the kilt big enough around at the hips. If you measure waist and hips, and use those measurements directly, you're in trouble if the person has a belly. In the kilt below, you'll see that the kilt is only big enough to go around the person snugly at both waist and hip. That means the kilt will be kind of a tilted cylinder, with the pleats on an angle instead of hanging straight down. The first pleat flops open under the influence of gravity.



Here's the same guy in a kilt where the kiltmaker added a few inches to the hip measurement, and then split the apron and pleats at the hips evenly. The kilt now hangs straight down in the front, no flopping first pleat. I've made kilts where I've had to add 5" or more to the hip measurement to have the kilt hang properly. Note - this is a case where sporran hangers are the best solution (a sporran strap would pull the kilt in under the belly and ruin the nice straight hang).



Many large guys also have a bigger waist than hip measurement, so adding inches at the hips to achieve a straight hang in the apron ALSO allows you to shape the back of the kilt to snug it into the small of the back. This not only helps the kilt hang better in the back, but it also prevents the kilt from slipping south, even on a guy with a relatively flat butt (because even when a guy THINKS he as no butt, he really does have something there).

[Steve Ashton]

On the issue that Barb brings up, I know of one kiltmaker who started learning in my shop and was taught my system but never did catch on to the idea of ease. He is now off on his own but still makes the rear hip split exactly what he measures leaving no ease in the back.



The causes the bottom of the Fell, at the steeking line, to pull in. This then causes every kilt he makes have the left and right apron edges, gape open.



Notice that even pressing and steaming the apron edge to curl inward, that there is still a gape at the first pleat.

Now, while this is different than the issue of the apron edge flipping outward it is still an illustration that kilt making is just a bit more complex than most people's first impression.