Thoughts on pleating to the stripe

[Barb T]

When you are pleating to the stripe, you don't have to pleat to one of the pivots. The red block looks wide enough to me that you could pleat to the red block that lies to one side of the double blue pivot. Why don't you try pinning that up and see what it looks like?

For a beginning kilmaker, getting a double stripe perfectly centered in each pleat, plus getting all the horizontal stripes to line up perfectly is a real challenge. My suggestion would be to pick either the solid red block or the solid green block, whichever you like the look of. That way, you would only have to match horizontal stripes.

But, ultimately, it really depends on which you like the best! Let us know what you decide!

[Flyboy]

Thank you all for your advice and opinions, I’ve taken it all in for contemplation. Barb on your advice I pinned a small section but to be honest I didn’t like it as much Without the vertical element as with pleating on the double blue pivot. My thoughts for this kilt in the pleated part anyway is to:

#1 to minimize the green
#2 to emphasize the red
#3 to maximize the blue

I think to achieve all of the above and leave some vertical element, pleating on the double blue pivot is the best option. As for the ease of it as a beginner the solid red option is tempting but maybe having the blue lines will make me extra conscious of my tension and stitches. I worked many years as a Funeral Director and Embalmer, so neat discreet stitching is my forte, so to speak ! Humour aside I’m not bad with a needle and thread. I Can also see how it goes with a few pleats and if it’s wobbly rip them out re-mark the tartan an start again on the solid red. I think the vertical element is something I really like in Shaun’s kilt above, so I think that’s my choice.

Thanks again,

Dick

[Barb T]

Go you! You might find the following post that I did a few years ago helpful! http://www.xmarksthescot.com/forum/f...-stripe-78527/