Hand Made Rob Roy Sporran!

[BLAZN]

The book is "So You Want to Wear a Kilt" by *cough* Thompson. Word has it that there's an appendix which includes a pattern for a nice Rob Roy sporran from which a few gents have produced great sporrans. Freelander sporrans are also based on this pattern, so I gather, and look damned fine.

[A Hay]

Congratulations on making your first sporran. I hope it won't be the last. There are so many possbilities to try.

I haven't tried a Rob Roy yet. I've been working on variations on traditional sporrans.

My first sewing also looked awful. What seems to work for me is cutting a shallow groove in the leather a uniform distance from the edge and then pre-punching the holes at uniform intervals. I do this on the stiff front and back panels, not the soft gusset. I punch the holes in the stiff panels, then line up the soft gusset and push the needle through the prepunche hole and through the gusset. Tandy Leather Factory has tools to do this and they are not too expensive. Then it becomes a matter of practice.

I'm working on sporran #6 over Christmas. The first 3 had major flaws, but the last two came out rather nice. I figure by the time I finish #10, I'll have it down.

Good luck on your next one!

Tom

[turpin]

Scroll down to the bottom of this page and check out the 1, 3, 4, and 8-prong punches.

http://www.tandyleather.com/products...EPT=210&Page=2

I used a 4-prong on my sporran. These punch a hole without removing the material. Then get some common embroidery thread for 5-30 cents a hank, and a piece of beeswax to wax the thread. Get some lacing needles (look like a regular needle but with a dull tip that won't catch on the work).

When punching, always insert one prong in the last hole you made. This keeps the hole interval uniform. Just do a running stitch from one end to the other of your work, and then reverse and go back to the beginning. Total outlay for tools and materials about $10-$20 US (not counting glue and dye, if you want to color your leathers like I did here.



which started out this color



I've never done any leather work before, so anyone with some patience who can thread a needle can do this.

[BLAZN]

Turpin... care to share your leather source? That looks like a nice piece of leather.