Please don't get me wrong, I was not suggesting you get an industrial machine.
At $2000.00 each they are way out of the range of the normal user and a waste of money. I need them because I do this for a living.
I was trying to show the table extensions and pressure foot height. The two things I consider in a machine over every other feature.

The curved "quilters pins" are what we use. Don't get the small ones. We also use alligator clips for those quick bastes. But you need a lot of each. I have a large metal ash tray in the shop that contains perhaps 200 quilters safety pins, another with about 100 alligator clips and literally thousands of straight pins in pin cushions all over the shop. You know, the ones with the big plastic ball on the end.

OH Yes, if you get the safety pins, always, ALWAYS, take the time to close the pins before you throw them back into the dish. That little few seconds of time it takes will save you many minutes untangling the open pins when you need to use them again.