Marking pleats to the Sett...

[Gilvray]

Thanks Barb - hope Band Practice was good...

I'm going to stick with the green stripe as center - and yes 5"1/4's TINY but its what I've got so I'm kinda stuck with it....

Following the book I've marked the apron, left a 9" gap fromn the bottom of the left hand side of the front apron and there are 17 repeats of the sett before the end of the length.

Having done some math based on a minimum pleat size at the waist of 5/8's I have 29 pleats. This seems to make me 2x sett repeats longer than expected - ie I was expecting to have 14 repeats between the apron and the centre back stripe.

So - should I make less pleats on the left length of fabric? I think that would mean my centre stripe is out of place.

So should I move my centre stripe 2 repeats toward the front apron, re-mark those marked pleats between and make the two lengths join where they need and I'll just have more fabric left over after I've marked the underapron...

It was suggested on another post to leave 2 sett repeats for the joining of the two lenghts...?

If I have to lose a foot then I have to...

Here's what I've got so far...

[ChattanCat]

Thanks Barb - hope Band Practice was good...

I'm going to stick with the green stripe as center - and yes 5"1/4's TINY but its what I've got so I'm kinda stuck with it....

Following the book I've marked the apron, left a 9" gap fromn the bottom of the left hand side of the front apron and there are 17 repeats of the sett before the end of the length.

Having done some math based on a minimum pleat size at the waist of 5/8's I have 29 pleats. This seems to make me 2x sett repeats longer than expected - ie I was expecting to have 14 repeats between the apron and the centre back stripe.

So - should I make less pleats on the left length of fabric? I think that would mean my centre stripe is out of place.

So should I move my centre stripe 2 repeats toward the front apron, re-mark those marked pleats between and make the two lengths join where they need and I'll just have more fabric left over after I've marked the underapron...

It was suggested on another post to leave 2 sett repeats for the joining of the two lenghts...?

If you have the fabric, I would use the 2x pleat option. It will give you a nice pleat length for the swing.

You need one repeat on the front side of the join and one repeat on the other half of the join. I have used less but only when I am trying to minimize the amount of material used because there just wasn't enough material for enough pleats. You will be ripping off what you don't use and these ripped pieces can be used for fringe, buckles, belt loops, and flashes.

Make sure you have enough material on the other half of the material to have the same number of pleats on each side of the join.

Welcome to kiltmaking!
Cheers,

[Barb T]

I think you'll find it hard to double the sett in the pleats. If you had a tartan with a 4" sett, you could do it. But doubling your sett would give you an effective repeat of over 10", and I don't think you'll be able to get enough pleats into your kilt with that (i.e., you'll have a small number of very big pleats).

So should I move my centre stripe 2 repeats toward the front apron, re-mark those marked pleats between and make the two lengths join where they need and I'll just have more fabric left over after I've marked the underapron...

Yes. If you want to have fewer pleats that are slightly bigger, you just mark more than half the pleats on the first piece of fabric. It doesn't matter that the join won't be in the center of the back - it won't show anyway. And, truly, it doesn't matter whether you use all the tartan or not.

If I have to lose a foot then I have to...

But better to have one longer piece left over at the end of your second piece than two short chunks from each piece!

BTW - when I'm laying out a kilt, I typically start by sticking pins in the tartan where I think I'll want the pleats. That gives me the option of moving them around a bunch before I decide. So, I check where I think I'll want the apron, and I stick a pin in where I think the center front will be, and the apron edges, too. Then I'll put a pin in at a possible center back, and I'll work back toward the apron edge, sticking a pin in where I think I want each pleat. If I have too many pleats, I'll go back and move the center back pin one repeat toward the apron, and move all the other pins again. If I still have too many pleats, I'll move the center back again. When I'm happy with the layout, I'll mark the pleats and the edges of the apron and take the pins out.

I actually don't use chalk to mark the pleats. Instead, I use a couple stitches of white basting thread. I typically cart the kilts I'm working on around, and I find that the chalk rubs off. Marking with basting thread is almost as fast, and I don't lose the marks.

Oh - and, as long as you lay out the center back pleat on the first piece of tartan, you'll always have enough tartan for the rest of the pleats on the second half. Because you have an odd number of pleats, you'll have one less pleat to lay out on the second half, and that will give you just enough for the inverted pleat next to the underapron. The only time you'd have to be careful is if you had a kilt with an even number of pleats. This might happen if you're pleating to the stripe, in which case it's easy to eliminate a pleat. It can also happen if you decide the split the center back between two pleats instead of having a center back pleat. If this happens, you do have to make sure you have enough tartan on the second half or else take out two (not one) pleats.

[Barb T]

BTW - in your photo, you've drawn an arrow to what you've labeled the left under apron edge. I assume that you mean the left *apron* edge?

[Gilvray]

Opps - yes - my mistake.... its the left apron edge (not the under apron). I think I'll move the centre pleat two repeats to the front apron, join it naturally and carry on.

Good tip on the pins and then basting thread! (I've got a 15 marked pleats to tap out and redo!)

Right - time to get some tea for the children, put them to bed and back to the job at hand!

Thanks for all the help everyone - I'm learning loads and despite the slow progress, I know that I'm heading in the right direction. Just hope the finished article is as tidy as all the others I've seen on the site here! You lot dont half make a good job of it - I've seen some lovely kilts looking at the albulms! Top stuff...

TTFN.

[Gilvray]

p64 of TAofKM states that the first pleat (left of the apron) and the last pleat (right of the underapron) should be mirror images of each other.

Is that identical copies or adjacent elements?

[Barb T]

p64 of TAofKM states that the first pleat (left of the apron) and the last pleat (right of the underapron) should be mirror images of each other.

Is that identical copies or adjacent elements?

They need to be mirror images of one another.