X Marks the Scot - An on-line community of kilt wearers.
-
21st July 11, 05:27 PM
#1
Apron Shaping
I'm sure this has been discussed but rather than searching, I'm curious what your current opinion is. I notice from TAoK that one inch is added to the apron edge where the fringe will be. Most of the pictures from kilts that Rocky has made I've noticed that the left edge is identical to the fringe edge (spacing is equal from the center front stripe to either edge). I understand that the extra inch is to ensure that the apron covers the underapron entirely. I'm just curious how you guys do it. I've considered adding half an inch to both sides. What are you thoughts on this. It may be a bad idea since I've noticed that my waist pleats measurement has come out almost a pleat width longer than it should. Perhaps take the measurement a bit tighter? What are your thoughts. Please share.
Paul.
-
Similar Threads
-
By Tiny in forum DIY Kilt and Accessories Help
Replies: 6
Last Post: 7th September 10, 05:15 PM
-
By Hothir Ethelnor in forum Professional Kiltmakers Hints and Tips
Replies: 6
Last Post: 5th December 09, 05:49 AM
-
By SergeantBort in forum DIY Showroom
Replies: 5
Last Post: 9th November 09, 06:15 PM
-
By Barb T in forum Hint and tips from Barb T.
Replies: 12
Last Post: 13th May 08, 07:27 PM
-
By ConfusedPollock in forum DIY Showroom
Replies: 7
Last Post: 19th September 07, 04:17 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|
Bookmarks