DIY Sgian Dubh 2.0

[MacGumerait]

Yes , I think you will be okay with grinding the steel . There are many grinding wheel drill bits that will easily grind metal .

Here is a pic that is similar to what you need :



There are many different types of these wheel bits , it depends on the hardness of the stone as to it's use . You should be able to pick one up at a local hardware store , check the info on the package to make sure it will grind metal .

Hope this helps , Cheers Mike .

[Nathan]

Yes , I think you will be okay with grinding the steel . There are many grinding wheel drill bits that will easily grind metal .

Here is a pic that is similar to what you need :



There are many different types of these wheel bits , it depends on the hardness of the stone as to it's use . You should be able to pick one up at a local hardware store , check the info on the package to make sure it will grind metal .

Hope this helps , Cheers Mike .

Thanks and happy birthday!

[Ron Abbott]

That's a good looking sgian dubh. I like the fact as well that's it's a one off....nobody else has one and it's a talking piece.

[MacGumerait]

Thanks and happy birthday!

Thank you Nathan !

[Bo On The Go]

Very nice work!

[Nathan]

So I ground down the protruding metal on the bolster with a bit I already had that was similar enough to Mike's. It took a long time, so perhaps it wasn't the exact tool for the job but I got it done. I followed the grinder bit with a file, then sand paper and then steel wool to smooth and polish everything.

Before:

IMG_20140716_083738.jpgIMG_20140716_083725.jpg


This is what I ended up with:

IMG_20140728_210240.jpgIMG_20140728_210228.jpgIMG_20140728_210247.jpg

[ASinclair]

Well done, Nathan, it looks good.