Just finished...

[BLAZN]

A 6.5 yard HAND SEWN in a BEAUTIFUL 10 ounce, wool, Dress Stewart.

I know everyone hates posts like this that are sans photos, but... too bad. The kilt will be unveiled at Arizona Ren. Fest this Saturday. There will be many a photo taken at that venue, many of which should find their way into the homes of X-Markers everywhere.

Just a little preview-like info:
I went with the interior strap on the left. Almost looks like something is missing on that side.
I did cheat a little on the waist... I got a tiny bit lazy and simply rolled everything over. Still looks good to me. You guys can pass judgement on me when I post pics.
The straps are suede. Gray suede. As in the same gray suede I used to make the sporran seen in this thread. They go so very well with the Dress Stewart tartan, it's mind boggling.

Anyway... I promise photos when I return to Maine from Arizona. Until then... he he he.

[Splash_4]

This is just cruel.... You enjoy teasing animals, don't you! Enjoy your time at the ren fair, but be warned, the rabble does not forget.

[The F-H.C.A.G.]

I second that-Bad X-Marker-no photos, no biscuit!

Be well,

[starbkjrus]

[McMurdo]

Cant wait to see it, congratulations.

[Fearnest]

No pics? That blows... in a purely nautical sense, of course...

[BLAZN]

No pics? That blows... in a purely nautical sense, of course...

I've been on a sub that's done that... and then some. On my first boat, during "post shake down trials," we had to do a full blow from test depth. I can't tell you the exact number, but I can say "in excess of 800 feet." A full blow means we dump the entire contents of our emergency air banks into the main ballast tanks. I forget the exact number, but that's A LOT of 4500psi air being dumped from DEEP. End result... the whole boat leaves the water at a 20+ degree up angle. Totally fun.

BTW... I'm in Phoenix now. Keep jonesin' for those pics.

[Fearnest]

Must be difficult to maintain steerageway in the Arizona canal...

And I'll tell you it's great fun to "jump" a tank ditch in a tank doing 45 MPH+... unless you hit the far side and stop dead (literally) or don't quite make it through all the concertina wire and spend the next 5 hours cutting it out of your sprockets with bolt cutters.

[BLAZN]

I thought I had posted this last night, but evidently it didn't work, so here it is again.

I promised pics of the newest kilt in my arsenal, and here they are.

These were taken after the AZ Ren Fest, once we got back to the hotel.

Front:


Back:


The doublet/vest was made by the wife. The Jacobite shirt that is sort of hidden by the doublet was made by the wife. Boots were something I bought from Silvermane, a ren faire vendor located in Haverhill, MA. The sporran is the very one I link to in the top post of this thread.
So basically, wwith the exception of the boots and belt, everything you see there was created by my wife or myself.

[KiltedCodeWarrior]

When you said Dress Stewart, I was not sure how it would look for a regular occasion kilt, but that looks nice.!