Critique

[sydnie7]

I think I did it as instructed (but memory doesn't always serve). Stitch seam, trim one allowance to 1/4", trim the other to 1/2", fold the 1/2" over the 1/4" and stitch along the fold. This results in three layers of fabric next to the seam.

Perhaps it should be only two layers? If I trim one allowance to 1/8 and the other to 3/8, so the two raw edges meet instead of overlapping but are both still encased and captured by the stitching.

The flat-fell finish is certainly nicer than the overcast raw edges, if I can get it right!

[Barb T]

Sounds right - it makes 3 thicknesses right at the seam. What weight tartan were you working with?

[sydnie7]

It is a lighter weight wool, not sure of the exact spec. Perhaps a combination of that, and my failure to stretch things really well while sewing pleats. It doesn't show unless I look real closely for it so I'll just stop looking for it!

Thanks for the book and all your follow-up on our efforts!

[Barb T]

If the tartan is 10 oz or less, I can see why the seam might show.