We've had people make Sgain Don'ts, Sgain Brew's, and Sgain everything else but last week one of our members asked about something I had not thought about.

So I now hereby present... The Sgain Shoe!!!!!

Ta-ta-de-ta. Let the trumpets announce, let the heralds proclaim.



I took a one piece plastic Safety Sgain from my display and cut the blade portion off.



If you will notice in the middle of the handle of these is a really nice Celtic Knot. But it is molded in black plastic so it does not show up well.
So I had some aluminum tape used by heating duct guys. I cut off a small piece and burnished it over the Celtic Knot. Working the metal into the design with the end of a matchstick.



Then i used a dremel tool to hollow out a socket in the handle where the blade was cut of and epoxyed in the blade of a shoe horn.



here is the other side.



Total time from start to finish about 20 min.